HOW TO REPAIR A COMPUTER WHEN HAS A PROBLEM?
Any irregularities in the process of using the computer indicate a problem with the machine, but there are also some simple problems that can be solved without the help of experts. Among the most common problems you may encounter is the problem of the computer freezing, showing the “won’t start” sign. To repair the computer In this case, you can follow these instructions:
This error can be caused by a hardware or software failure, so you need to find out its exact cause. Note if the problem starts when you connect any hardware peripherals like a printer or a scanner then it could be due to a driver conflict. Or if the problem occurs after installing a new hard drive, it could be due to insufficient power or too much heat. Once you have identified the above cause, you can do the following:
Step 1:
If you leave your computer on often, turn it off, then unplug it (or remove the battery if it’s a laptop). Then hold down the power button for 30 seconds while the computer is still plugged in (this usually causes a light, or light, to flash), then reinsert the battery, plug it in, and power it on. By cutting power to the motherboard, it allows the hardware to reset the memory more accurately.
Step 2:
If it’s hot, then there may be a heat problem. For laptops, you can check the fan ports. Because too high temperature is not good for devices, please gently check the front and back of the fan for dirt, use a clean cloth to clean the dust layers (note: turn off the computer before doing this) .
If you have multiple hard drives in your computer, avoid installing them right next to each other, but buy an additional hard drive bracket to take advantage of places like the CD-ROM or DVD-ROM drive slot. Even if your computer doesn’t have problems, you should still clean it periodically.
Step 5: Check your device drivers .
Many times when Windows Update operating system, your system can download and install an incorrect driver by itself, leading to computer freezing. You can check the driver’s status in Device Manager. Any devices with a yellow exclamation mark next to them indicate they are in an error state.
If you have a peripheral connected, unplug it to see if the error goes away. If the error goes away then the problem lies with these devices. Turn on your computer and see if it works. If yes, fine; otherwise you can restore your computer to a previous configuration.
Step 6: Use System Restore
Access System Restore by pressing and holding the Windows Logo key and pressing R, typing “rstrui” in the Run dialog box. Use a restore point to restore your computer, possibly removing the software (application, driver, or update) causing the problem.
Once started, System Restore cannot be interrupted, so please wait patiently. Note that it will not be possible to undo changes to your PC using System Restore if you are running it in Safe Mode or Windows Recovery Environment.
Step 7: Check your hard drive .
The hard drive is a store of information, so when used for a long time it can have problems; This slows down the performance of your computer. Therefore, use the Windows CHKDSK utility to periodically scan and remove bad sectors. This is the best precaution to maintain the stability of the computer.
Step 8: Install and run the best anti-virus and malware program .
Step 9: If all else fails, reinstall your operating system .
Be sure to back up your files before doing this step.
Above are the instructions to repair the computer when the machine unfortunately does not start
